Office hours Monday to Friday, 7 AM to 5 PM. Licensed plumbers on call 24/7 for plumbing emergencies. Call 979-473-9775

4L Contracting LLC

FAUCET AND FIXTURE REPAIR IN COLLEGE STATION AND BRYAN, TX

  • Five star ratedOn Google, by our customers
  • LicensedTexas Master Plumber 40980
  • On call 24/7Licensed plumbers for emergencies
  • Brazos ValleyCollege Station, Bryan and nearby

A dripping faucet, a shower that will not hold temperature, a stop that no longer closes: small faults with a large nuisance value. Most come down to a worn part inside a fitting that is otherwise fine.

The useful question is never how old the fixture is. It is which part has given up, and whether the rest of the assembly is worth keeping.

4L Contracting repairs and replaces faucets, valves and household fixtures for property owners in College Station, Bryan and the nearby Brazos Valley communities. Written pricing comes before authorized work begins.

Call 979-473-9775Request an Appointment

A plumber working under a pedestal sink in a bathroom

Kitchen faucets, sprayers and the connections under the sink

The kitchen faucet is the hardest worked faucet in the property. A cartridge or valve seat that has worn now drips. A stiff or sloppy handle makes every use a small frustration. A pull-out spray head that has lost pressure or will not retract is usually the hose behind it, not the head itself. The cabinet below deserves the same attention. Water running down a supply line soaks into the base. It shows as a swollen panel or a smell long before it shows as a puddle. We look under the sink as part of the call rather than only at the part you pointed at. If water is appearing in a cabinet with no obvious source, that is a different investigation, and leak detection is the right starting point.

Bathroom faucets, pop up drains and sink stoppers

Bathroom fittings fail differently because they are smaller, used more gently and left standing wet. Drips at the spout are common. So is seeping at the base where the faucet meets the counter. The corrosion that quietly happens under a basin often goes unnoticed until the countertop or vanity beneath it is already damaged. The pop-up assembly deserves its own mention. The lift rod, the pivot and the stopper that will not seat, will not lift or will not hold water in the basin. It is one of the most frequent calls we take, and almost nobody knows what the mechanism is called before they call. We replace the parts that are worn where parts are obtainable, and we say plainly when they are not.

What our customers say

Published exactly as written, straight from Google.

  • Found late Friday evening that I did not have hot water, and it was the weekend... YIKES!! Contacted 4L Contracting LLC; they came out within a couple of hours and had me working in a short time. Lee went above and beyond, letting me know about other problems identified in my attic, a problem with my chimney, and a heating vent installation problem. After he left, I found a water leak in the laundry room ceiling. He turned around and came back to my house. He found the air conditioning drain pipe was backed up. He blew it out the drain pipe, preventing a big disaster. So appreciate his thoroughness and helping me on a Friday after-hours house call. He definitely went above and beyond.

    Laurie CunninghamGoogle Review
  • I had a great experience working with 4L Contracting LLC. They were awesome to work with, they were professional, responsive, and clearly knew what they were doing. We had a massive leak that needed immediate attention, and they showed up quickly and handled it efficiently. They not only fixed the issue fast but also made sure everything was done right. I would absolutely recommend them to anyone needing reliable, high quality work!

    Jada WoolleyGoogle Review
  • Used 4L Contracting the first time a couple years ago and since then they have replaced a water heater, reset toilets, replaced water lines, and located and fixed a leak under the house! They have been amazing to work with over the years, I cannot recommend these guys enough!

    Mary JohnsonGoogle Review
  • Water Softener installation Completed! Just wanted to give a shout out to Kurt and Lane on their outstanding customer service today. I hired 4L Contracting LLC to install a water softener in our home. After finding out the water softener I had purchased was missing parts, the job was rescheduled for Monday. I was able to return the water softener and get a replacement fairly quick. So I sent a text to Kurt, letting him know I had done so. He informed me they were nearby and could do the job in about 30 minutes if I could meet them back at my home. I hurried home and in about 2 hours the job was completed. Tonight my wife and I shall enjoy a soft water shower!

    Sam StathakosGoogle Review
  • My husband and I had a broken pipe in the foundation and it was leaking pretty bad into our hallway, and 4L Contracting came that day we called, assessed the issue, and was back the next day and completely fixed the problem. They were so nice and helpful! I cannot tell you how pleased we were with their service. I recommend 4L Contracting!

    Kim PagachGoogle Review
  • My wife and I discovered a water leak coming out of our wall. 4L Contracting LLC came out that day and found where the leak was coming from (copper pipe leaking in the slab), they started working immediately and finished the next day.

    Stephen PagachGoogle Review
  • These plumbers are honest, knowledgeable and reliable! They helped us fix a leak and answered all our questions about other issues in the house. Highly recommend!

    Kaitlin WeathersGoogle Review
  • Lee and his guys are Great. Their communication on our projects have been superb! Always letting us know when they will be at the job site. Lee is doing 3 projects for our Airbnb's at one time, and his organization of his paperwork is paramount for us.

    Michael WimberlyGoogle Review

Read all reviews on Google

WHAT IT COSTS AND HOW YOU PAY

Price in Writing Before Work Starts

You get a written price covering the scope we recommend and what it includes. No verbal estimates. No extra charges added after the fact. You approve the scope and cost before we start.

Workmanship Warranty

Every installation we perform is backed by a workmanship warranty. If a problem with our work develops within the warranty period, we return and fix it at no charge to you.

Office Hours and Emergency Availability

Office hours Monday to Friday, 7 AM to 5 PM. Licensed plumbers on call 24/7 for plumbing emergencies. Reach us at 979-473-9775.

Shower valves, cartridges, diverters and a temperature that wanders

This is the section where customers are most often told the wrong thing, so we will be clear. A shower may run hot then cold, never reach a comfortable temperature, or feel stiff or loose at the handle. That is usually the cartridge. It can also be the internal parts of the mixing valve. It is not the water heater. The diverter is a separate fault. Water going to the tub spout when it should go to the head, or splitting between the two, is a worn diverter. It is not a pressure problem. Shower valve work often means opening the wall behind or beside the valve. We discuss that access with you before we start, not after. Wall repair and tile work are typically a separate trade. If the bathroom is being rebuilt rather than repaired, that project fits remodel plumbing better than a service call.

A new shower valve roughed in behind an opened wall

Slow drains at the fixture rather than out in the line

The trap under a sink, the tailpiece, the pop-up assembly and the tub drain and overflow all collect hair, soap and debris. They slow down long before the line beyond them does. A single slow fixture with everything else in the property draining normally is a fixture problem. Several slow fixtures at once, gurgling sounds, or water rising in one place when another is used all point to the drain line itself. That is a different job. We clear and reassemble the fixture drain properly rather than pouring something down it and hoping.

Angle stops, supply lines and a shutoff that will not shut off

Every sink, toilet and appliance connection should have a stop that actually isolates it. An old stop can seize open, weep at the stem, or close only partly. The fixture then cannot be worked on, or stopped in a hurry when it matters. Flexible supply lines age. The connection at either end is a common source of a slow drip inside a cabinet. So we replace them while we are already at the fixture, rather than leave a marginal line behind. Before we leave, we show you where the stop for the fixture is, and where the main shutoff for the property is. That knowledge is worth more than any part we installed.

Hose bibs and outdoor spigots on the side of the house

Outdoor spigots take the worst of the weather and the roughest handling. Watch for a bib that drips when it is off, a handle that spins without closing, or a spout that moves in the wall. Water showing up inside a wall or garage when you use the outdoor spigot is the same warning. A hose bib passes through the building envelope. A fault there can put water into a wall cavity rather than onto the ground, and that is the version worth attending to quickly. A hose left connected over a freeze is a common way to damage the fitting behind the wall. That damage often turns up the following spring, when the faucet is first opened. We replace the bib and check what it is connected to, not only the part visible outside.

Not sure where to start?

Talk to a licensed plumber

Describe what your plumbing is doing and we will tell you what it likely is before anyone comes out.

Garbage disposals that hum, jam or leak underneath

A disposal that hums without turning has something jammed and a motor that is stalled. A disposal that is silent entirely is a power, reset or switch question before it is a mechanical one. A disposal leaking from its body or from the connection to the sink or drain is usually the end of that unit. A disposal is fixed to the sink and tied into the drain, and often into the dishwasher. So replacing one is a plumbing connection job rather than a straight appliance swap. The electrical supply under the sink is its own consideration. A disposal is not a way to dispose of grease. Grease going down a kitchen line is the reason that line eventually needs cleaning. We tell a customer when a unit is not worth repairing rather than charging to find that out twice.

Low pressure at one fixture compared with low pressure everywhere

Poor flow at a single faucet or shower head is almost always local. It might be a blocked aerator or spray face, mineral buildup in a cartridge, or a partly closed stop. It can also be a supply line that has been kinked or crushed under a sink. The mineral buildup version is common here, because the groundwater in this part of Texas is hard. Some owners are dealing with scale as a household condition rather than as one blocked aerator. They may want to look at water softeners and whole-home filtration as a longer answer. Poor pressure at every outlet in the property is a different investigation entirely. It involves the supply into the building and the condition of the existing piping. Whole-home repiping is where that conversation starts.

Repair or replace, and how fixture work is put in writing

Four things drive the decision. Whether parts for that fitting are still obtainable, and whether the body of the fixture is sound. Whether this fault has already been repaired before, and whether you were planning to change the fixture anyway. We will repair a serviceable fitting rather than sell a replacement, and we will say when a repair is only a short term answer. The plumber sees the fixture and identifies the scope, then we put the pricing in writing and you authorize the work before it starts. Some things only turn up once we are into the job: corroded connections behind a wall or under a sink, a damaged counter, a stop that fails when it is finally moved. We explain those and get them approved separately. Our workmanship warranty applies to the work performed, with covered work, exclusions and customer obligations stated in the written proposal, authorization or invoice. Manufacturer coverage on a new fixture is separate from 4L workmanship coverage. Details on how pricing works are at our plumbing prices page.

FAUCET FIXTURE REPAIR NEAR YOU

We work across College Station, Bryan and the towns around them. Pick your town, or check whether we cover your area.

BryanCollege StationSurrounding areas

Book a faucet or fixture repair

Most jobs start the same way: a drip, a stiff valve, a shower that will not hold temperature, a failed stop, a disposal replacement. Any of them begins with Request an Appointment. Some things cannot wait. A burst supply line, a stop that will not close on running water, or water spreading through a cabinet or a wall. The right move then is to call 979-473-9775 directly.

Office hours Monday to Friday, 7 AM to 5 PM. Licensed plumbers on call 24/7 for plumbing emergencies.

Request an AppointmentCall 979-473-9775Get a starting price

Common questions

My shower runs hot then cold. Is that the water heater?

Usually not. A shower that runs hot then cold, never reaches a comfortable temperature, or feels stiff at the handle is usually the cartridge. It can also be the internal parts of the mixing valve. This is the fault customers are most often told the wrong thing about.

Water goes to the tub spout instead of the shower head. Is that low pressure?

No. That is a worn diverter, and it is a separate fault. Water going to the tub spout when it should go to the head is the diverter. So is water splitting between the two. It is not a pressure problem.

One faucet has poor flow and the rest are fine. What causes that?

Poor flow at a single faucet or shower head is almost always local. It might be a blocked aerator or spray face, mineral buildup in a cartridge, or a partly closed stop. It can also be a supply line kinked or crushed under a sink. Poor pressure at every outlet is a different investigation.

Do you have to open the wall to fix a shower valve?

Often, yes. Shower valve work usually means opening the wall behind or beside the valve. We discuss that access with you before we start, not after. Wall repair and tile work are typically a separate trade.

Will you repair a fixture, or try to sell me a new one?

We repair a serviceable fitting rather than sell a replacement, and we say when a repair is only a short term answer. Four things drive the decision. Whether parts for that fitting are still obtainable. Whether the body of the fixture is sound. Whether this fault has been repaired before. And whether you were planning to change the fixture anyway.

My garbage disposal hums but will not turn. What does that mean?

A disposal that hums without turning has something jammed and a motor that has stalled. One that is silent entirely is a power, reset or switch question before it is a mechanical one. A disposal leaking from its body, or from the connection to the sink or drain, is usually the end of that unit.

Is one slow sink a drain problem?

Not usually. A single slow fixture, with everything else draining normally, is a fixture problem. It sits in the trap, the tailpiece, the pop up assembly or the tub drain. Several slow fixtures at once, gurgling sounds, or water rising in one place when another is used all point at the drain line itself.

Do you look at anything besides the part I point at?

Yes. We look under the sink as part of the call. Water running down a supply line soaks into the base. It shows as a swollen panel or a smell long before it shows as a puddle. Before we leave we show you where the stop for that fixture is, and where the main shutoff for the property is.

How is fixture work priced?

The plumber sees the fixture and identifies the scope. We put the pricing in writing, and you authorize the work before it starts. Problems hidden behind a wall are discussed and approved separately. That covers corroded connections, a damaged counter, or a stop that fails when it is finally moved.

Have a plumbing question? Contact an expert.